Filter
Top Products
OPTION PROGRAMMING
9. PARKING LIGHTS ON WITH DISARM
Keeps parking lights on instead of 2 flashes when system is disarmed to assist in locating your vehicle in a crowded
parking lot or structure. Light will stay on for 30 Sec. or until Ignition is turned on.
10. DISARM WITH AUX. OUTPUT 1 (TRUNK POP)
Controls whether the system will or will not DISARM when the trunk pop or AUX. feature is used. When the feature is
turned on the unit will DISARM when opening trunk or using an auxiliary device controlled by the Gray output wire.
11. SILENT ARM / DISARM WITH REMOTE BUTTON #3 (SHORT PRESS)
With this feature, the system can be programmed to Arm and Disarm without a siren chirp using a short press and
release of Button #3 (TRUNK) on the remote transmitter.
12. DOOR LOCK/UNLOCK PULSE TIME
Controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required for
1980’/90’s European Vehicles that require a long pulse to do Vacuum door lock systems.
13. ACTIVE, PASSIVE, or FULL-TIME CARJACK PROTECTION
This feature controls the type of Carjack protection the alarm will provide. There are 3 selections: Button 1 (Lock) =
Active protection. Button 2 (Unlock) = Passive protection. Button 3 (Trunk) = Full-Time protection. Option number 14
must be enabled to allow Carjack functions to operate. See Operation : Carjack.
14. CARJACK FEATURES
This option controls the unit’s Car Jack features. Enable or Disable Carjack (Turn ON or OFF) with this option.
15. ARM/DISARM with IGNITION ON
Use this option to control whether the system can be armed or disarmed while the Ignition is turned ON. This may be
required to allow arming of this system when used in conjunction with a separate remote starting system.
OPTION RESET (RESTORE TO DEFAULT VALUES)
NOTE: The programming options of the CS2002DC can be reset to ALL DEFAULT (*) values. See chart on page 9 for
values with (*).
Perform option programming Step #1, then press button #3 (Trunk). The siren will chirp 4 times and lights will flash 4
times. Turn OFF Ignition. All programming options should be restored to “*” values (See chart Pg. 9).