Filter
Top Products
WIRING
BLUE/WHITE WIRE: (-) PASSENGER(S) DOOR UNLOCK OUTPUT (Optional, requires relay)
Connects to unlock circuit for passenger door(s) when using separate driver’s door unlock option. See
SEPARATE DRIVER’S DOOR UNLOCK WIRING on Page 8 for some configuration options.
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to RED siren wire from the Siren in the engine compartment.
WHITE WIRE: PARKING LIGHT OUTPUT: +12V or (-) Negative Ground (Jumper Selectable)
Connect to switched +12V parking light wire at back of light switch. If this is not possible, connect directly to
one of the parking lights at the front of the vehicle. If your vehicle requires a (-) Negative Ground signal to
activate the parking lights, then you have to move the jumper located on the circuit board inside the unit. For
European vehicles with separate right and left circuits, use a dual relay or 2 diodes to separate the output
signal. The DEFAULT output is Positive. Carefully snap open the control module and see illustration below.
JUMPER
PLUG
SIDE VIEW
JUMPER
PINS
NEGATIVE LIGHTS
CS-2002DC IV MODULE
+12V POSITIVE LIGHTS
CS-2002DC IV Parking light output: The jumper plug inside the control
module determines the unit's (+) or (-) Parking Light output. Use the jumper
pin to select Positive or Negative Polarity Output. (*Default = Positive)
(DEFAULT)
TOP VIEW OF P4 JUMPER
5