Filter
Top Products
OPERATING INSTRUCTIONS
ACTIVE RE-ARMING (FAIL-SAFE PROTECTION)
Active Re-arming means that the system will re-arm itself 30 seconds after disarmed with the transmitter if a door has
not yet been opened. This is handy if the vehicle is accidentally disarmed (via the transmitter in your pocket) without
you knowing it. This feature can also be turned off in programming option (4). If programmed for Passive Chirp
Countdown, the unit will emit a chirp every 2 seconds until the system Active Re-arms. Active rearm feature is
disabled if you also have dome light illumination installed.
2
nd
AUX. OUTPUT (REMOTE AUX. OUTPUT 2)
To activate the Second auxiliary output press the Bank#2 Button on the side of the remote first, then Press Button #4
(Panic) to activate AUX. channel #2.
ARM/DISARM WITH IGNITION ON (PROGRAM OPTION #15)
This feature allows the system to be armed or disarmed while the ignition is in the ON position or vehicle is running.
The feature is disabled by default and should not be used under normal operating conditions. On an installation with
an add-on remote start module, this option can be enabled to allow the system to be armed or disarmed when the
vehicle has been remote started (Ignition will be ON). Note that you cannot use this feature if you are also using the
Full-time carjack protection. If you add a remote start and the Ignition turns on, a Carjack trigger will be activated.
CARJACK PROTECTION FEATURES
ACTIVE CARJACK
This feature provides Active Carjack protection and must be enabled before use through Alarm programming option
(14) See page 10. When the Ignition is on (vehicle is running), press button #4 (Panic). Parking lights will flash
TWICE to confirm the Carjack countdown sequence. LED begins to flash slowly. 90 Seconds later, the unit will begin
a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into a full system activation with siren/flashing
light pulses for up to 7 ½ min. To reset Active Carjack, IGNITION MUST BE ON, then press Button #2. Siren/Horn
chirp, LED goes OFF, carjack is reset.
PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming options
(13) & (14). See page 10. We recommend this mode should only be used in serious situations. When the Ignition is
on (vehicle is running), and a door is opened and closed, the Carjack countdown sequence will be initiated (lights flash
twice & LED begins to flash). 90 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-
warning chirps turning into a full system activation with siren/flashing light pulses for up to 7 ½ min. To reset Passive
Carjack, Ignition must be ON, doors must be closed, then press the override/program button (3) times. Siren chirps
once, LED goes out, carjack is reset. NOTE: Active carjack can still be used when the Passive Type carjack is
activated.
17