Crimestopper Security Products CS-2002DC Automobile Alarm User Manual


 
OPTION PROGRAMMING
7. DOUBLE UNLOCK PULSE
With this feature enabled, the unit will send 2 unlock pulses when the #2 Unlock button is pressed. 2 pulses
are required for interfacing into some existing Factory Keyless Entry or Alarm systems on vehicles such as
Nissan, VW, Toyota, and Lexus vehicles.
8. SILENT ARMING /DISARMING (CHIRP DEFEAT)
With this feature, the system can be programmed to Arm and Disarm without the siren chirp using the regular
Lock/Unlock Buttons. Flashing parking lights will be the only Arm/Disarm confirmation.
9. PARKING LIGHTS ON WITH DISARM
Keeps parking lights on instead of 2 flashes when system is disarmed to assist in locating your vehicle in a
crowded parking lot or structure. Light will stay on for 30 Sec. or until Ignition is turned on.
10. DISARM WITH AUX. OUTPUT 1 (TRUNK POP)
Controls whether the system will or will not DISARM when the trunk pop or AUX. feature is used. When the
feature is turned on the unit will DISARM when opening trunk or using an auxiliary device controlled by the
Gray output wire.
11. N/A, No option
12. DOOR LOCK/UNLOCK PULSE TIME
Controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required
for 1980’/90’s European Vehicles that require a long pulse to do Vacuum door lock systems.
13. ACTIVE, PASSIVE, or FULL-TIME CARJACK PROTECTION
This feature controls the type of Carjack protection the alarm will provide. There are 3 selections: Button 1
(Lock) = Active protection. Button 2 (Unlock) = Passive protection. Button 3 (Trunk) = Full-Time protection.
Option number 14 must be enabled to allow Carjack functions to operate. See Operation : Carjack.
14. CARJACK FEATURES
This option controls the unit’s Car Jack features. Enable or Disable Carjack (Turn ON or OFF) with this option.
15. ARM/DISARM WITH IGNITION ON
This option controls whether the unit will allow arming and disarm using the remote when the ignition is on (or
vehicle is running). This program option may need to be enabled when using an Add-on remote starter to
allow the alarm to be armed or disarmed after remote engine starting. Note that you cannot use this feature if
you are also using the Full-time carjack protection. If you add a remote start and the Ignition turns on, a
Carjack trigger will be activated.
12