Filter
Top Products
2
Table of Contents
Using Your Remote Starter ...................................................... 3
Starting Your Vehicle
If your vehicle stalls or does not start
Remote Start Safety Features
Entering the Vehicle While it is Running via Remote Start
Pre-Heating or Pre-Cooling the Interior of the Vehicle
Turning on the Rear-Window Defroster
Using the “Quick-stop” Feature
Basic Troubleshooting .............................................................. 4
System Layout .......................................................................... 5
Programmable Options ............................................................ 6
Code Alarm WarrantyPlan ....................................................... 8
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that
may cause undesired operation.
Warning!
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
7
Note: Skip this step if the vehicle does not have a tach wire or if this
unit will be programmed to operate without connection to the tach wire.
1. Open the vehicle hood (hood pin switch must be installed to
program tach).
2. Following the steps in Section C (Programming Selectable
Options), access Option Bank 2 / Feature 4.
3. Start the vehicle with the key, and allow the engine to come to a
normal idle (5-10 seconds).
The unit will flash the parking lights every three (3) seconds to
indicate that it has learned the current idle speed.
Default settings in BOLD
OPTION DESCRIPTION
Option Bank 1 - 4 Chirps (Car Start Options)
STATUS INDICATOR
1.Tach Mode (1) Use blind crank timing (2) Use tach input ON(1) OFF(2)
2.Blind Crank Time (1) Avg of last 8 manual starts (2) 1.5 sec. ON(1) OFF(2)
3. Run Time (1) 25 minutes (2) 12 minutes ON(1) OFF(2)
4.Diesel Mode Start crank begins (1) 15 sec. or ON (1) OFF(2)
5. Positive Start Trigger (1) Single Pulse Start (2) Double Pulse Start ON(1) OFF(2)
Option Bank Two - 5 Chirps (Installer Options)*
1. Lock Sense Switch (1) Positive (2) Negative ON(1) OFF(2)
2. Neutral Safety Input (1) Positive (2) Negative ON(1) OFF(2)
3. Tach Programming** Hood open, Start to learn ON OFF
Brake is used instead of door to enter learn mode.
* The Installer options will never reset.
** For Tach Averaging, both Starter Key and Starter Motor wires must be hooked up.
Programmable Selectable Options, (cont’d)
Programming the Tach Signal
Programmable Options Chart