Cobra Electronics XRS 930 Radar Detector User Manual


 
Pop Alert
The Pop Mode Radar Gun is a single-pulse Doppler radar that is a feature
of a K and Ka (Bee III Ka radar gun) band Instant-On radar gun. It uses
a single, short-time pulse to measure the target vehicle’s speed.
The Pop mode receiver senses Pop singles beyond the effective range of Pop
radar guns. As the Pop mode receiver is so sensitive, you should limit the use of
Pop Detect mode to highway and rural driving.
Pop Alert will alert you to Pop radar signals. During the alert, the unit
continues to detect other signals. The factory setting is Pop Detect Off.
Your Detector
Settings Settings
Your Detector
To Turn VG-2 and Spectre I & IV+ Alerts On and Off
While no signal is being
detected, press and
hold the Dim button
for four seconds.
Tone
Visual Display
On = Two beeps
Off = One beep
V will blink twice in the display
V will blink once in the display
Dim Button
Press and hold
for four seconds
VG-2 and Spectre I & IV+ Alert Settings
Police use radar detector detectors (RDDs) to spot users of radar detectors.
Your detector is able to identify signals from VG-2, Spectre I and Spectre IV+ RDDs
and can provide alerts when any of these or similar devices are in use
near your vehicle.
Your detector can be spotted by Spectre IV+ RDDs, but is invisible to VG-2 and Spectre
I RDDs. You can choose whether you want to be alerted to VG-2 and Spectre I & IV+
RDD signals. The factory setting for VG-2 and Spectre I & IV+ alerts is Off.
On/Off Indicator
X K Ka V S
c
Nothing Comes Close to a Cobra
®
13
English
12
IntelliMute Pro
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2,
Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for use by
experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector’s radar detection circuits are turned Off to prevent
detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set the
IntelliMute activation point. (See pages 9 through 11.)
To Turn IntelliMute Pro On
While no signal
is being detected,
press and hold both
the IntelliMute and
City buttons for
four seconds.
Tone
Visual Display
Two beeps c or h will blink
To Turn IntelliMute Pro Off
Press and hold both
the IntelliMute and
City buttons for
four seconds.
Tone
Visual Display
One beep c or h will show steady
IntelliMute Pro On
X K Ka V S
c
IntelliMute Button
City Button
Press and hold both
buttons simultaneously
To Turn Pop Alert On and Off
While no signal is being
detected, press and
hold both the
Dim and City buttons
for four seconds.
Tone
Visual Display
Pop On = Two beeps P will blink twice in the display
Pop Off = One beep
P will blink once in the display
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
XRS930_MANL:9492-XRS9330 12/18/09 8:28 AM Page 12