Filter
Top Products
English
16 17
Adjusting Camera Settings
Adjusting Camera Settings
Your Dash Cam
Your Dash Cam
To Adjust General Settings
•
General Settings
Beep Sound
If you don’t want the device to beep on every button press, turn
this option OFF.
Idle Power Off
Automatically turns the unit off if no buttons are pressed within 1
or 5 minutes if no video is being recorded.
Date/Time
Use this to set the current time and date.
Date Format Sets the date format.
TV System Lets you choose between NTSC (United States) and PAL (Europe)
HDMI Output Lets you choose between 720P and 1080P on the HDMI Output.
Screen Flicker This sets the screen refresh rate. Options include 50 Hz and 60 Hz.
USB Function
If you want your camera to behave like a Mass Storage device
(ash drive) when connected to a computer, select MSDC. If you
want to use it as a webcam with your computer, select PCAM.
Screen Rotate Allows you to ip the screen vertically for upside-down operation.
Screen Saver
Allows you to set a timeout for the screen to go black when not in
use. Options include 1 minute and 3 minutes.
G-Sensor Level Sets the sensitivity of the G-Sensor, from 0 (off) to 4 (max)
Motion Detector Sets the sensitivity of the Motion sensor, from 0 (off) to 3 (max)
GPS Status
This allows you to view the raw data from the GPS satellites that
are available in your area.
Time Zone Select Set the time zone you’re currently in.
Restore Defaults Resets the system to its default settings.
Format SD-Card
If you want to completely erase all the movies and les on the SD-
card, select this option. Be careful; all your data will be lost.
SD-Card INFO See how much space remains on the SD Card.
FW Version Get the rmware version information.
NOTE: If you are currently recording video ( ) you’ll
need to stop recording with the OK button rst.
While in VIDEO or STILL PHOTO mode, press the
MENU button once to enter the menu selection
screen. Press the down arrow until General Settings
is highlighted, then press OK to conrm.
Press the UP and DOWN arrows to select the setting
you’d like to modify, then press the OK button to
conrm.
A window on the right edge of the screen will display
the available options. Use the UP and DOWN arrows
to make your selection, then press OK to conrm.
A list of the settings and their meanings are shown on the
next page.