Filter
Top Products
4. Note that the QuietChirps feature is in the same column 2, row 5. Simply press the
momentary side 5 times.. After a brief pause, you’ll hear two chirps to confirm that
the QuietChirps feature is now on.
5. To exit the program mode, turn the ignition off. You’ll hear 3 chirps to confirm
program mode exit.
You just made three programming changes in only five steps. Easy, isn’t it? Notice
again that in this instance, you did not have to re-select column 2. If you don’t touch
the switch, the system
stays
in the column for 10 seconds to allow you to select any
other feature(s) in the same column without having to re-enter the column number.
Of course, you can also toggle the latched side to select a new column.
If you wait more than 10 seconds, the system automatically jumps back to the
“Feature Select” position. This is the “stand-by” position: ready for entry of a new
programming selection. If no action is taken for the next 60 seconds, the system
automatically exits program mode, perfect if you program while driving or if you
forget to turn off the ignition.
Adding new remote controls
For other drivers in your family, or if you wish to control Concept 50x systems on
your other cars with the same remote control, you can buy additional remote
controls from any Clifford Dealer and program them into the system yourself. Each
Concept 50x will respond to as many as four 12-channel ACG remote controls. To
add a new remote control to the system, use the procedures noted in the
User-selectable features
section on pages 16-20.
How to erase the codes of lost or stolen remote controls
If one of your remote controls is ever lost or stolen, you can erase its digital codes
from the system memory to make sure that the missing remote control can never be
used to disarm your system. To do so, use the “Erase all channels” feature (feature
column 1, row 5 on the
Table of user-selectable features
on pages 19-20). This will
clear all remote control codes from the system memory. Then simply program each
remaining and/or replacement remote control as noted in the Adding new remote
controls
section above.
18