Clifford concept 50 Automobile Alarm User Manual


 
How to interpret the chirps and indicator light flashes
When you use the remote control, the system responds with chirps (unless the chirp muting
feature is turned on) and indicator light flashes:
Chirps and flashes Meaning
1 Your Concept 50 system is disarmed
2 Your Concept 50 system is armed
2 and then 4 Armed but one of the sensors is malfunctioning (see Smart AutoTesting on page 13)
3 Disarmed and there was an intrusion attempt (see Smart prior intrusion attempt on page 14)
4 Armed but the bonnet or boot is open (see Smart AutoTesting on page 13)
Smart AutoTesting
When remotely armed, your Concept 50 tests all triggers and sensors. If the
bonnet
or boot is open when you arm, your Concept 50 will immediately alert you of the
problem by issuing 4 chirps and 4 indicator light flashes instead of the usual 2 and
2. If one of the
sensors
is malfunctioning, you’ll receive the usual 2 chirps and
flashes, then, 5 seconds later, there will be 4 chirps and 4 flashes.
Specific malfunction identification: The system can also indicate the specific
malfunctioning trigger or sensor. This saves you time and money since your
installer won’t have to spend hours trying to determine where the problem is:
1. When you insert your key and turn on the ignition, the LED indicator inside the
vehicle will be flashing, pause, then repeat.
2. Count the number of flashes in one cycle between pauses (for your convenience,
the flash cycle repeats 5 times) and refer to the chart below:
Number of LED flashes between pauses Malfunction
1 flash Volumetric Radar Sensor
2 flashes Glass Tampering Sensor
4 flashes Boot trigger
5 flashes Bonnet trigger
Automatic malfunction bypass
To provide the utmost protection even if a system component malfunctions, your
Concept 50 will automatically bypass the faulty point and arm all
other
triggers and
sensors until you can have the system serviced by your local Authorised Clifford
Dealer. If you accidentally armed the system with the boot or bonnet open, simply
disarm, close it, then rearm. The system will then monitor that point again.
13