Filter
Top Products
TotalRecall™
The system’s memory records the identity of the last activated or malfunctioning
trigger or sensor, which allows your installer to instantly track down a malfunction. To
identify the trigger or sensor held in the system’s memory, use the following procedure:
1. With the ignition OFF, flip the valet switch.
2. Press button I to “arm” the system, then again to “disarm.”
3. The LED will blink 1–3 times to indicate the most recently activated trigger or
sensor. For your convenience, the blink cycle will repeat a total of 5 times.
4. Write down the number of blinks between pauses and refer to the chart below.
Fault-Proof starter interrupt
Your Arrow II will automatically prevent the engine from being started while the
system is armed. Clifford’s Fault-Proof design ensures that you can start the engine
even in the unlikely event of a system malfunction.
High-output siren with remote controlled chirp muting
Sounds when the system detects an intrusion attempt or when panicked (see page 5).
Chirp Muting
Siren “chirps” confirm arming and disarming, but you have two options: remote chirp
muting and long-term chirp silencing. Remote chirp muting is useful when parking in a
quiet residential area or any other time when you want to arm or disarm silently. To do
so, simultaneously press
both
buttons I and II on your remote control instead of the
usual button I. The system will arm or disarm with all the usual indications except
the siren chirp(s). Long-term chirp silencing lets you set turn off the chirps until you
decide to turn them back on. Just use the programming procedure noted on page 10.
SmartPowerUp™ II
If power is ever removed, SmartPowerUp II ensures the system will automatically
restore itself to its previous state when power is restored. So if a thief disconnects
power and then restores it in an attempt to start the car, the system will re-arm and
instantly sound the siren. If your vehicle is to be serviced by a mechanic, just put the
system in valet mode (see page 8). If the mechanic needs to interrupt power, your
system will automatically return to its valet mode state when power is restored;
there will be no alarm activation and no need to provide your mechanic with your
remote control and instructions on how to use it.
Number of LED blinks between pauses Trigger/sensor indication
1 blink Piezo Sensor
2 blinks Door trigger
3 blinks Hood or trunk trigger
9