Clifford 330X1 Automobile Alarm User Manual


 
14
© 2008 Directed Electronics-all rights reserved
QUICK REFERENCE GUIDE:
To arm the system
You can arm the system by locking the doors with your factory keyless entry
transmitter. When the system arms, your will hear a short chirp, and see the
indicator lights flash once.
To disarm the system
To disarm the system, unlock the doors using your factory keyless transmit-
ter. You will hear two chirps, and the indicator lights will flash twice.
Disarming without a transmitter
Turn On the ignition.
1. Enter 4-digit PIN code by turning the ignition On, press the button the
same number of times as the 1st digit.
2. Turn the ignition Off, and On.
3. Press the button same number of times as 2nd digit, turn the ignition
Off and On.
4. Press the button same number of times as 3nd digit, then turn ignition
Off and On.
5. Press button same number of times as 4nd digit, then turn the ignition
OFF.
If the code was correctly entered the system will disarm.
To enter or exit Valet
®
Mode
Turn ignition to “run” position, then turn to “Off” position. Press and release
the Valet®switch within 10 seconds. The status LED will light solid if you are
entering Valet® Mode, and it will go out when exiting Valet® Mode.
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
G330X_1-3_2008_02B.qxd 2/14/2008 4:28 PM Page 14