Cisco Systems 6500 Series Automobile Parts User Manual


 
2-10
Catalyst 6500 Series Supervisor Engine Guide
OL-7397-03
Chapter 2 Supervisor Engines
Supervisor Engine 32
Memory
Switch Processor DRAM 256 MB (supervisor engines shipped before May, 2005)
512 MB (supervisor engines shipped after May, 2005)
Upgradeable to 1 GB using MEM-xCEF720-1GB memory kit
Route Processor DRAM 256 MB (supervisor engines shipped before May, 2005)
512 MB (supervisor engines shipped after May, 2005)
Upgradeable to 1 GB using MEM-xCEF720-1GB memory kit
Switch Processor
Bootflash/Bootdisk
256 MB
Route Processor Bootflash 64 MB
CompactFlash (disk0) Compact flash Type 2 (supports 64, 128, 256, 512 MB, and 1 GB
Front panel features
Status LEDs See Table 2-8 for a list of the status LEDs and their descriptions.
RESET switch The RESET switch allows you to reset and restart the switch.
Note Because the reset switch is recessed in the faceplate, you must use a
ballpoint pen tip or other small, pointed object to access the switch.
CONSOLE port This is a 10/100/1000 port that uses an RJ-45 connector. The CONSOLE port
allows you to access the switch either locally (with a console terminal) or
remotely (with a modem). The CONSOLE port is an EIA/TIA-232
asynchronous, serial connection with hardware flow control.
DISK 0 (PCMCIA) slot and
LED
One PCMCIA slot is available. The PCMCIA slot allows a Flash PC card to
be installed providing additional flash memory. You can use this flash
memory to store and run software images or to serve as an I/O device. An
eject button is located on the left side, next to the slot. Pushing in on the
button ejects the PCMCIA card from the slot.
The PCMCIA slot has an LED associated with it.
Table 2-6 Supervisor Engine 32 Features (continued)
Feature Description