Cisco Systems 6500 Series Automobile Parts User Manual


 
1-3
Catalyst 6500 Series Supervisor Engine Guide
OL-7397-03
Chapter 1 Catalyst 6500 Series Switch Chassis Overview
Catalyst 6504-E
Supervisor Engine 32 and Supervisor Engine 32 PISA do not support the Switch Fabric Modules
(WS-C6500-SFM and WS-X6500-SFM2) and cannot be installed in the same chassis.
The uplink ports are fully functional on the redundant supervisor engine when it is in standby mode.
Note In systems with redundant supervisor engines, both supervisor engines must be the same model
and have the same daughter card configurations. Each supervisor engine must have the resources
to run the switch on its own, which means that all supervisor engine resources are duplicated.
Identical supervisor engine memory configurations are recommended but are not required as
long as the supervisor engine with the smaller memory configuration is sufficient to run the
configured features of the switch. Additionally, each supervisor engine must have its own flash
device and console port connections.
Additional information on the Catalyst 6503-E switch chassis including data sheets and chassis
installation is located at:
http://www.cisco.com/en/US/products/hw/switches/ps708/tsd_products_support_series_home.html
Catalyst 6504-E
The Catalyst 6504-E switch is an enhanced 4-slot (numbered from (1) top to (4) bottom), 5 RU,
horizontal chassis that supports redundant power supplies and redundant supervisor engines. The
Catalyst
6504-E switch chassis is NEBS L3 compliant. Supervisor engine support and restrictions for
the Catalyst
6504-E includes:
Supervisor Engine 2, Supervisor Engine 32, Supervisor Engine 32 PISA, Supervisor Engine 720,
Supervisor Engine
720-10GE, and the Supervisor Engine 2T are supported.
Note Refer to your software release notes for specific information on the minimum software release
versions required to support the supervisor engines in the Catalyst
6504-E chassis.
Supervisor engines must be installed in slot 1 or slot 2.
Note Slots not occupied by supervisor engines can be used for modules. Check your software release
notes for any restrictions on the type of module that can be installed.
Supervisor Engine 720, Supervisor Engine 720-10GE, and Supervisor Engine 2T have a built-in
switching fabric. Switch Fabric Modules (WS-C6500-SFM and WS-X6500-SFM2) are not
supported by Supervisor Engine
720, Supervisor Engine 720-10GE, and Supervisor Engine 2T and
cannot be installed in the same chassis.