Chrysler SRT6 Automobile User Manual


 
CAUTION!
To avoid possible damage to the tonneau cover and
convertible top, do not allow the convertible top to
remain in the suspended position. After approxi-
mately 10 minutes in the suspended position an
audible beep will be heard and the hydraulic pres-
sure will be released which will allow the top and
the tonneau cover to lower. The convertible top
switch can be pressed to cancel this operation.
CAUTION!
To avoid damage to either the top or the rear win-
dow, check the tonneau cover area at the rear of the
vehicle interior to be sure that it is clear of debris or
other items. Do not use the tonneau cover area for
other storage purposes.
CAUTION!
To fully insure that no damage occurs, be sure that
the vehicle is at a complete stop before attempting to
lower or raise the top.
NOTE:
If the top does not operate or stops during the
raising or lowering procedure, start the engine and
continue operation.
1. Make sure the rear cargo compartment divider is
unfolded and secured in the vertical position. A slow
audible information signal will be heard and the convert-
ible top switch lamp will flash slowly if the cargo
compartment divider is not in the vertical position. If the
divider is in its stowed position, first unfold the panels
towards the rear of the vehicle. Pull up on the vertical
panel using the center cutout shown, and hook the pins
at the top into the brackets mounted to the cargo com-
partment trim on each side near the forward edge of the
decklid opening. The pins must be hooked in these
brackets in order for the top to operate.
NOTE:
See label attached to underside of decklid.
54 UNDERSTANDING THE FEATURES OF YOUR VEHICLE