Chrysler 2007 Town and Country Automobile User Manual


 
Improper alignment will not cause vehicle vibration.
Vibration may be a result of tire and wheel out-of-
balance. Proper balancing will reduce vibration and
avoid tire cupping and spotty wear.
TIRE CHAINS
Use only compact chains, or other traction aids that meet
SAE type “Class S” specifications. Chains must be the
proper size for the vehicle, as recommended by the chain
manufacturer.
NOTE: Do not use tire chains on a compact spare tire.
CAUTION!
To avoid damage to your vehicle or tires, observe the following
precautions:
Because of restricted chain clearance between tires and other
suspension components, it is important that only chains in
good condition are used. Broken chains can cause serious
damage. Stop thevehicle immediately ifnoise occurs that could
indicate chain breakage. Remove the damaged parts of the
chain before further use.
Install chains on the front wheels as tightly as possible and
then retighten after driving about
1
2
mile (0.8 km).
Do not exceed 45 mph (70 km/h).
Drive cautiously and avoid severe turns and large bumps,
especially with a loaded vehicle.
If chains are used on an All Wheel Drive (AWD) vehicle, they
should be used on all four tires.
Do not drive for prolonged period on dry pavement.
Observe the tire chain manufacturer’s instructions on the
method of installation, operating speed, and conditions for use.
Always use the lower suggested operating speed of the chain
manufacturer if different than the speed recommended by the
manufacture.
STARTING AND OPERATING 341
5