Filter
Top Products
key is turned “ON”. The frequent use of outside air will
help keep odors from building up within the air
conditioner-heater housing. It is recommended that the
recirculation mode be used as little as possible, especially
in humid climates.
For hot and dry climates, or people who are allergic to
pollen and find frequent use of the recirculation mode
necessary, the recirculation mode can be programmed to
not automatically reset to the outside mode by using the
following procedures:
•
Turn the ignition switch to the OFF position.
•
Press and hold the recirculation button.
•
While holding the recirculation button, turn the igni-
tion switch to the “RUN” position.
•
Continue holding the recirculation button for 4 sec-
onds, then release.
The recirculation control is now programmed so that the
recirculation mode will not reset to the outside air mode
when the engine is restarted. The recirculation program-
ming can be changed back by repeating this procedure.
Rear Fan Operation
To operate the rear fan, press the ЉREARЉ button. The first
time this button is pressed the ЉREAR AUTOЉ display
will illuminate indicating that the rear fan speed is
automatically controlled. To manually control the rear
fan speed, press the ЉREARЉ button again and only
ЉREARЉ will illuminate in the display. This allows the rear
seat occupants to control the rear fan speed using the
switch located in the center console between the second
row seats. By pressing the ЉREARЉ button a third time,
the rear fan will shut off.
202 UNDERSTANDING YOUR INSTRUMENT PANEL