Chrysler 2004 Sebring Coupe Automobile User Manual


 
Operation
Press and hold the desired button (A, B or C) on the
universal transceiver until the garage door or other
device begins to operate. The indicator light (D) shows
that the signal is being transmitted. The hand held
transmitter (E) may also be used at any time.
NOTE:
If you have difficulty in programming, call toll-free for
customer assistance at 1-800-355-3515, or the internet
at www.homelink.jci.com.
If your hand held transmitter appears to program the
universal transceiver, but your garage door or other
device does not operate, and your device was manu-
factured after 1996, your garage door opener or other
device may have a “Rolling Code” system.
To check if your device is protected by a “Rolling Code”
system:
Check the owner’s manual for the device for mention
of “Rolling Code”.
The hand held transmitter appears to program the
universal transceiver but the universal transceiver
does not activate the garage door.
Press and hold the programmed button on the univer-
sal transceiver. If the indicator light (D) flashes rapidly
and then stays on after 2 seconds, the device has the
“Rolling Code” feature.
“Rolling Code” Programming
On garage door openers with the “Rolling Code” feature,
the transmitter code changes after each use to prevent the
copying of your code. Set the universal transceiver by
following these steps:
NOTE:
The assistance of a second person may make the
following programming procedure quicker and easier.
134 INSTRUMENTS AND CONTROLS