Chevrolet colbat Offroad Vehicle User Manual


 
So, it is not a good idea to top off your brake/clutch
fluid. Adding fluid will not correct a leak. If you add fluid
when your brake linings are worn, then you will have
too much fluid when you get new brake linings.
You should add or remove fluid, as necessary, only
when work is done on the brake/clutch hydraulic system.
{CAUTION:
If you have too much brake fluid, it can spill on
the engine. The fluid will burn if the engine is
hot enough. You or others could be burned,
and your vehicle could be damaged. Add brake
fluid only when work is done on the brake
and/or clutch hydraulic system.
When your brake fluid falls to a low level, your brake
warning light will come on. See Brake System Warning
Light on page 3-29.
What to Add
When you do need brake fluid, use only DOT-3 brake
fluid. Use new brake fluid from a sealed container
only. See Recommended Fluids and Lubricants on
page 6-12.
Always clean the brake fluid reservoir cap and the area
around the cap before removing it. This will help keep
dirt from entering the reservoir.
{CAUTION:
With the wrong kind of fluid in your
brake/clutch system, your brakes/clutch may
not work well, or they may not even work at
all. This could cause a crash. Always use the
proper brake fluid.
Notice:
Using the wrong fluid can badly damage
brake/clutch system parts. For example, just a
few drops of mineral-based oil, such as engine
oil, in your brake/clutch hydraulic system can
damage brake/clutch system parts so badly
that they will have to be replaced. Do not
let someone put in the wrong kind of fluid.
If you spill brake fluid on your vehicle’s painted
surfaces, the paint finish can be damaged.
Be careful not to spill brake fluid on your
vehicle. If you do, wash it off immediately.
See Washing Your Vehicle on page 5-87.
5-37