Filter
Top Products
15. If the flat tire was able
to inflate to the
recommended inflation
pressure, remove
the maximum speed
label from the sealant
canister.
The maximum speed label reminds you to drive
cautiously and not to exceed 55 mph (90 km/h)
until you have the damaged tire inspected
and repaired.
16. Place it in a highly visible location such as the
inside of the upper left corner of the windshield
or to the face of the radio/clock.
17. Return the equipment to the proper storage location
in the rear of your vehicle. To do this, insert the tire
sealant and compressor kit back into the foam
container and place the foam container onto the
storage bracket. Securely tighten down the
foam container with the foam retainer bolt.
{CAUTION:
Storing the tire sealant and compressor kit
or other equipment in the passenger
compartment of the vehicle could cause injury.
In a sudden stop or collision, loose equipment
could strike someone. Store the tire sealant
and compressor kit in the proper place.
18. Reverse Steps 1 through 4 under Accessing the
Tire Sealant and Compressor Kit earlier in this
section.
19. Immediately drive the vehicle 5 miles (8 km) to
distribute the sealant evenly in the tire. Stop at a
safe location and check the tire pressure, refer
to Steps 1 through 8 under Using the Air
Compressor without Sealant next in this section.
If the tire pressure has not dropped more than
10 psi (68 kPa) from the recommended inflation
pressure, you can inflate the tire back up to
the recommended inflation pressure.
5-81