Filter
Top Products
If you use the RKE transmitter to enter the vehicle and
the remote recall memory feature is on, automatic seat
and mirror movement will occur. See “MEMORY SEAT
RECALL” under DIC Vehicle Customization
on
page 4‑79
for more information.
To stop recall movement of the memory feature at any
time, press one of the power seat controls, memory
buttons, power tilt wheel control, or power mirror
buttons.
If something has blocked the driver seat and/or the
steering column while recalling a memory position, the
driver seat and/or the steering column recall may stop.
If this happens remove the obstruction, then press the
appropriate control for the area that is not recalling for
two seconds. Try recalling the memory position again
by pressing the appropriate memory button. If the
memory position is still not recalling, see your dealer
for service.
Easy Exit Recall
The control for this feature is located on the driver door
panel between buttons 1 and 2.
With the vehicle in P (Park), the exit position can be
recalled by pressing the exit button. You will hear a
single beep. The driver seat will move back, and if the
vehicle has the power tilt wheel and telescopic steering
feature, the power telescopic steering column will move
up and forward.
If the easy exit seat feature is on in the DIC, automatic
seat and power telescopic steering column movement
will occur when the key is removed from the ignition.
See “EASY EXIT RECALL” under DIC Vehicle
Customization
on page 4‑79
for more information.
Further programming for automatic seat and steering
wheel movement can be done using the Driver
Information Center (DIC). You can select or not select
the following:
.
The easy exit recall feature
.
The memory seat recall feature
For programming information, see DIC Vehicle
Customization on page 4‑79.
2-7