Filter
Top Products
Turn and Lane-Change Signals
To signal a turn, move the lever all the way up or
down. The lever returns automatically when
the turn is complete.
An arrow on the
instrument panel cluster
will flash in the
direction of the turn or
lane change.
Raise or lower the lever until the arrow starts to
flash to signal a lane change. Hold it there until the
lane change is complete. The lever returns to its
original position when it is released.
Rapid flashing of arrows when signaling for a turn
or lane change may be caused by a burned-out
signal bulb. Other driver’s will not see the signal.
Replace burned-out bulbs to help avoid possible
accidents. Check the fuse and for burned-out bulbs
if the arrow fails to work when signaling a turn.
See Fuses and Circuit Breakers on page 455 for
more information.
Turn Signal On Chime
If the turn signal is left on for about
3
⁄
4
mile
(1.2 km), a warning chime will sound and the
TURN SIGNAL ON message will appear on the
Driver Information Center (DIC) display. See “Turn
Signal On” under DIC Warnings and Messages
on page 220 for more information.
168