Filter
Top Products
3. Lower the front rollers to the lower guides and
pull the system back until the middle set of
rollers clear the upper guides.
4. Lower the system until the middle rollers are
lined up with lower guides. While holding in
the release lever or tab, push the system
forward until all three sets of rollers are on
the guides.
5. Release the lever or tab and push the system
until the locator pin reaches the locator hole.
To adjust the system from the lower guide to the
upper guide, do the following:
1. Squeeze and hold the release lever, or slide
the tab towards the inside of the vehicle,
to retract the locator pin.
2. Pull the system back until the middle rollers
can be raised and placed into the upper
guides.
3. Push the system forward until the front rollers
are lined up with the vertical curved guides.
4. Push down on the rear of the system and
raise the front rollers up the vertical curved
guides.
5. Push the system forward until all three sets of
rollers are resting on the guides and release
the lever or tab.
6. Push the system forward until the locator pin
reaches the locator hole.
The cargo management system can be pulled out
and used as a table on both the upper and
lower guide. To use a table, squeeze the release
lever and pull the system towards you. Release
the lever and pull the system until the locator pin
reaches the next hole. The system will extend
out of the vehicle. The liftgate can not be closed
in this position. Do not the operate the vehicle
with liftgate open.
The cargo management system can be removed
from the vehicle. This procedure should be
completed by two people. While squeezing the
release lever, pull the system back until the
rollers clear the guides.
177