Filter
Top Products
36
Using the traffic congestion function
Regardless of whether or not your TravelPilot DX-V is able to receive information from
a TMC source (“TMC D-Namic tuner box” or appropriately equipped Blaupunkt car
radio), you can enter a traffic congestion detour manually. As a result, you can alter
your route quickly on the basis of the traffic situation (e.g. road works, closed sections
of road, etc.). The TravelPilot DX-V will then calculate a new route to bypass the traffic
congestion. In order to do this, you must know the distance of the beginning and the
end of the traffic congestion from your current position. You can also exclude entire
roads from the route list.
Activating the traffic congestion function
1. To activate the traffic congestion function, press
!
on the remote control
while route guidance is in progress. The “Congestion” menu will appear. ✔
2. Mark . Press
OK
.
The “Congestion” menu for manual entries will appear. ✔
3. Select “Congestion ahead”. Press
OK
.
A menu in which you can enter the beginning and the end of the traffic con-
gestion will appear. ✔
4. Press the button to mark the lower value. This value is used for setting
the distance from your vehicle position to the start of the traffic congestion.
Use the
buttons on the remote control to move the arrow to set the
distance of the beginning of the traffic congestion from your vehicle position.
The distances you can set are dependent on the course of the navigation
route.
5. Press the
button to mark the upper value. This value is used for setting
the distance from your vehicle position to the end of the traffic congestion.
Use the buttons to set the distance to the end of the traffic congestion.
6. Press the
OK
button. The icon is marked.
7. Press the
OK
button again. Route guidance is displayed and you will hear
the following voice output: “The route is being calculated”. ✔
Route guidance