Filter
Top Products
88
©
2004 Directed Electronics, Inc.
Press to disarm the security system when it is already armed.
If the power locks are controlled by the system, the doors will also
unlock. Disarming is confirmed when the parking lights flash twice
and the siren emits two chirps. The LED system status indicator will
also stop flashing. The siren chirping either four or five times when
disarming indicates Tamper Alert, which is described in the
Diagnostics section of this guide.
If your remote is lost or damaged, you can manually disarm your
vehicle security system. To disarm the system without a remote,
you must have the vehicle's ignition key and know where the
Valet® switch is located. Be sure to check with your installer at the
time of installation for the location of the Valet® switch.
To disarm the security system,
turn the ignition key on and
press the Valet® switch within
15 seconds. The system should
now disarm. If the system does not disarm, you may have waited
too long to press the Valet® switch; turn the ignition off and
repeat the process.
LLooccaattiioonn ooff VVaalleett®® SSwwiittcchh________________________________________________________________
DRW-35
DDiissaarrmmiinngg WWiitthhoouutt aa RReemmoottee
AUX
DDiissaarrmmiinngg