Filter
Top Products
1122
©
2005 Directed Electronics—all rights reserved
To turn the rear defogger output ON:
1. Simultaneously press & release the ++ buttons
on the remote control.
2. The lights will flash 3 times.
3. The rear defogger output will once again activate when the
vehicle is remote started.
NNOOTTEE::
If the remote start is on the lights will turn off then flash
3-times before returning to their normal output and the defog-
ger output will activate as programmed.
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
TToo ppeerrffoorrmm VVaalleett TTaakkee--OOvveerr::
1. Before turning off the engine, press and release twice
within 2 seconds (or press and release the optional Momen-
tary switch).
2. Turn the ignition key to the OFF position.
(The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or
a shut-down input is received. (See the previous Remote Start
section for a complete list of shut-down inputs.)
NNOOTTEE::
This feature will not work if the brake pedal is being pressed.
VVaalleett TTaakkee--OOvveerr