Filter
Top Products
24
© 2008 directed electronics—all rights reserved
To enter or exit Valet Mode using the remote:
Steps 2 through 3 must be quickly and smoothly completed.
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
setting the clock
To set the clock press and hold for five seconds, the trans-
ceiver will chirp twice and the hour selection will start flashing.
Immediately press to advance the hour selection or to
reverse the hour selection. Once the correct hour is displayed
press again and the minute selection will start flashing. Then
press to advance the minute selection or to reverse the
minute selection. Once the correct time is displayed simply stop
pressing any buttons for 15 seconds and the transceiver will auto-
matically exit the clock mode.
nuisance prevention
®
circuitry
Your system has Directed’s Nuisance Prevention
®
Circuitry
(NPC
®
). It prevents annoying repetitive trigger sequences due to
faulty door pin switches or environmental conditions such as
thunder, jackhammers, airport noise, etc.
➜
➜