Filter
Top Products
© 2001 Directed Electronics, Inc. Vista, CA 33
features menu
The factory default settings are indicated in bold text in the table below.
feature descriptions
1 ENGINE CHECK ON/OFF: In the default setting the remote start will monitor either the vehicle's tach wire or
voltage depending on the programming of Feature 2. If programmed off, the vehicle will crank for the pro-
grammed crank time (Feature 5) and will not verify with tach or voltage that the vehicle is running. In the off
setting, if the vehicle fails to start, the ignition can stay on for the entire run duration. Using tach or voltage
check is always recommended if possible.
2 TACH WIRE SENSE/VOLTAGE SENSE: If the tachometer signal wire is used, this feature must be left in the
default (tach wire connected) setting. If programmed to the voltage sense setting, the unit will crank the starter
for a preset time that can be programmed in Feature 5. Once the starter has been engaged, the system will check
the voltage level to verify the engine is running. The threshold for the voltage level test can be programmed in
Feature 6. When using voltage sense mode, connection of the H2/5 VIOLET/ WHITE tachometer input is not necessary.
FEATURE DEFAULT - LED ON SETTING LED OFF SETTING
NUMBER (PRESS CHANNEL 1) (PRESS CHANNEL 2)
1 Engine checking on Engine checking off
2 Tachometer checking type Voltage checking type
3 12 minutes run time (1)* 24 minutes (2), 60 minutes (3) run time
4 Flashing parking light output Constant parking light output
5 Cranking time 0.6 sec. (1) Cranking time 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5),
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) sec.
6 High voltage check level Low voltage check level
7 Auxiliary output: factory alarm disarm Auxiliary output: special accessory
8 Normal status output Factory re-arm output
9 Activation pulses: 1 (1) Activation pulses: 2 (2), 3 (3)
10 Ignition-controlled locking on Ignition-controlled locking off
11 Ignition-controlled unlocking on Ignition-controlled unlocking off
*NOTE: The numbers in parentheses indicate the number of times the LED will flash