Filter
Top Products
21
Y. SECOND VEHICLE SECURITY OPERATION:
Your 5-button remote transmitter can be utilized to control a second vehicle
security system, To program the remote control transmitter to a second vehicle,
follow the instructions for Transmitter programming.
Programming the Transmitter to 2
nd
Car
Enter:
1. Turn the ignition key ON 3 times. (Finishing in the ON position)
2. Press valet switch 2 times, holding in on the 2
nd
push, you will hear a
long siren chirp. (Release the valet switch)
3. Press the shift button of the Car 2 transmitter.
** LCD transmitter must be put in 2
nd
car mode to program for 2
nd
car.
(See next page)
4. Press the lock button on the transmitter; you will hear 1 siren chirp.
Turn OFF the ignition switch; you will hear 3 long siren chirps to confirm
programming and exit transmitter programming
** For 2-way LCD Display Transmitter:
2nd
Car Operation:
1. Press first, within 3 seconds press and hold and
buttons at the same time for 2 seconds. Two beeping sound
and the “ ” icon will be displayed
on the LCD screen to
indicate the second transceiver pin code is programmed.
2. While the “ ” icon is displayed on the LCD screen,
you
can remote control
and communicate with a second vehicle
security system. It has two short “bi” sounds
while pressing the
button of the LCD screen transceiver.
Back to 1st Car Operation:
1. Press first, within 3 seconds press and hold and
buttons at the same time for 2 seconds. One long
beeping
sound and the “ ” timer icon will be displayed
on the
LCD screen indicating the system is back to the
first
transceiver pin code.
2. While the “ ” timer icon is displayed
on the LCD
screen, you can remote control
and communicate with the first
vehicle security system. It has one
short “bi” sound while
pressing the button of the LCD screen transceiver.
Z. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to
remember its alarm state if the power is lost and then reconnected
.