Audiovox NVX226 GPS Receiver User Manual


 
Getting started
Congratulations on your purchase of the AUDIOVOX NVX226 system.
Your AUDIOVOX NVX226 system can guide you to the destination of your
choice using signals from Global Positioning Satellites (GPS) orbiting the
earth.
There are 24 GPS satellites orbiting the earth. A GPS device can calculate
your position on the earth if it can receive signals from at least three of
these satellites. When it receives at least four signals, a GPS device can
also calculate your altitude (height above sea level).
To use the AUDIOVOX NVX226 system for the first time you need to
charge the battery, and install the map loader into your computer only
when you require Canadian mapping. You can install the map loader while
the battery is charging. When using the unit in the United States, map
loader is not required to be loaded on your PC. The map for the United
States is pre-installed on the 1 Gig memory card.
Charging the battery
To charge the battery, plug the power cable into the AUDIOVOX NVX226
system and into a power outlet. Let the battery fully charge (approximately
4 hours).
1 User’s Manual