Filter
Top Products
128-8208
1 of 2
Transmitter Programming Guide
This transmitter is designed for use with your upgrade remote start
unit and is programmed by using the remote start's program switch in
combination with the transmitter button. Although this transmitter can
be programmed into any of the Audiovox remote start and or alarm,
alarm remote start systems, it will offer limited use and should be
used for the remote start upgrade only.
To program this transmitter into your remote start upgrade unit:
1) Turn the ignition to the on position
2) Press and release the programming switch 3 times
3) Press and hold, for 3 seconds, the button of the transmitter you
wish to add until the parking light flashes indicating the transmitter
has been learned.
4) Repeat step 3 for each transmitter up to a total of 4.
Turn the ignition off to exit the program mode.
NOTE: Do not allow more than 15 seconds to lapse between steps
or the program mode will be automatically exited and you will have to
start over.
Replacing The Batteries:
Model 07S1BP
Using the edge
of a coin, or a
small flat
screwdriver
blade, carefully
remove
transmitter back
cover keeping
hold of the metal
key ring to
prevent it's loss.
Carefully remove the
discharged batteries
by sliding them out
from under the clip in
the direction indicated
by the arrow,
Properly dispose of
the exhausted battery
and insert two new
CR1220 taking care to
arrange it so that the
+ is facing up away
from the circuit board.