ATON DLA2RM Universal Remote User Manual


 
LIMITED WARRANTY
ATON* warrants to the purchaser/end user (“you”) that the DLA2RM/DLA4RM/DLA6RM is to be free from defects in materials and workmanship for a period of one (1) year from date of purchase (the “Warranty
Period”). This warranty is transferable to subsequent owners of the product as long as the original proof of purchase is retained. If you discover a defect in material or workmanship within the Warranty Period,
you can obtain warranty service by contacting ATON during the Warranty Period at (859)-422-7137 or service@atonhome.com. If ATON determines that the product is in fact defective, ATON shall, at its option,
repair or replace the product free of charge to you.
This warranty shall not apply to equipment (a) not manufactured by ATON, (b) to equipment which was improperly installed, (c) which was repaired or altered by persons other than ATON or its authorized repre-
sentatives or subject to unauthorized tampering, alteration or modification, (d) damaged due to misuse, negligence, accident, acts of God (including, but not limited to, excess moisture, insects, lightning, flood,
electrical surge, tornado, earthquake, or other catastrophic events beyond ATON’s control), or (e) subject to improper operation, maintenance or storage or unreasonable use. The foregoing warranties do not
cover reimbursement for labor, transportation, removal, installation or other expenses which may be incurred in connection with repair or replacement. The foregoing remedies shall be your exclusive remedies
for any breach of warranty.
Further, the foregoing warranty does not extend to equipment sold, but not manufactured by, ATON (“Third Party Products”). With respect to any Third Party Products, the warranty for such product shall be as
provided by the manufacturer of such product, who will also be responsible for warranty service, and ATON will pass through to you any transferable warranty actually extended to ATON by the manufacturer.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESSED AND IMPLIED WARRANTIES. ATON EXPRESSLY DISCLAIMS ALL SUCH OTHER WARRANTIES, INCLUDING BUT NOT LIMITED
TO IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT. Notwithstanding the above, where applicable, if you qualify as a “consumer” under the
Magnuson-Moss Warranty Act, then you may be entitled to any implied warranties allowed by law for the Warranty Period. Some states do not allow limitations on how long an implied Limited Warranty lasts, so
the above limitation may not apply to you.
ATTENTION: TO OUR VALUED CONSUMERS
Valid proof of purchase is required for all warranty services. Warranty service requests made without proof of date of purchase will be denied. Please keep the original sales receipt for your records and send a
copy to request warranty service.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
* ATON is a division of ELAN Home Systems, LLC.
ROOM 1
ROOM 1 ROOM 1
ROOM 2
ROOM 2 ROOM 2
ROOM 3ROOM 3 ROOM 4 ROOM 4
ROOM 5 ROOM 6
ALL
ON
ALL
ON
ALL
ON
ALL
OFF
ALL
OFF
ALL
OFF
SCENE SCENE SCENE
MUTE MUTE MUTE
VOL
+
VOL
+
VOL
+
VOL
_
VOL
_
VOL
_
Place included
Room labels here
ATON
PORT
PATENT
PENDING
PWR IN
12VDC / 2.1A
AMPLIFIER
INPUT
IR EMITTER
OUTPUTS
RF
Receiver
DLA2/4/6 or DLA2RF
RJ-11
Plug
Button Function
Room 1-6 Selects Rooms for Adjustment
All On Turns All Rooms On
All Off Turns All Rooms Off
Scene Places Rooms into Scene Preset Mode
Mute (Toggle) Press to Reduce Volume of Selected Room to 0, Press
Again to Increase Volume to Previous Level
Vol + Increases Volume of Selected Room by One Step
Vol - Decreases Volume of Selected Room by One Step
DLA2RM/DLA4RM/DLA6RM
RF Remote
The DLA2RM, DLA4RM and DLA6RM RF Remotes are accessory remote con-
trols designed to work with ATON models DLA2RKT, DLA4RKT and DLA6RKT
RF Remote/Receiver Kits. These remotes will function as additional control-
lers when added to existing RF Receiver installations or as replacement units.
Note: These remotes will not function without an installed RF receiver.
RF Remotes
Make sure RF receiver is plugged into the DLA ATON Port
and that the DLA Selector is powered On (power supply is plugged in).
Remove the access cover from the bottom of the RF receiver.
Press and release the Program button - Program LED will turn solid.
Within 10 seconds press and release the “Scene” button on the
remote you wish to program into the receiver.
If the remote is programmed into the receiver correctly, the program
LED will immediately turn off.
Repeat steps 3-5 for additional remotes (up to seven remotes can be
programmed into one receiver).
NOTE: Only ONE RF receiver can be used per DLA Selector. Program all ad-
ditional remotes into the original RF receiver. The remote that is included
with the original RF Remote/Receiver Kit is pre-programmed to the
receiver and will function without additional programming.
Programming the RF Remote to function with the RF Receiver
1
2
3
4
5
6
D4
S1
JP1
JP2
JP3
JP4
D4
S1
JP1
JP2
JP3
JP4
Access Cover
RF Receiver
Program Button
Program LED
P/N DLARMINS REV:A
DLA2RM-2 Room DLA4RM-4 Room DLA6RM-6 Room
www.atonhome.com
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: Any changes or modifi cations not expressly approved by ATON could void the user’s authority to
operate this equipment.