Filter
Top Products
American DJ®
4295 Charter Street
Los Angeles Ca. 90058
www.americandj.com
Introduction:
Thank you for purchasing the F-700™ by American DJ®. The F-700™
has been tested at the factory and is ready to be used, there is no
assembly required. Please read the following instructions and safety
precautions before attempting any installation or using your new F-
700.™
Customer Support:
American DJ® provides a toll free customer support line, to provide set
up help and to answer any question should you encounter problems
during your set up or initial operation. You may also visit us on the web
at www.americandj.com for any comments or suggestions. For service
related issue please contact American DJ®. Service Hours are Monday
through Friday 9:00 a.m. to 5:00 p.m. Pacic Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2610
E-mail: support@americandj.com
Warning! To prevent or reduce the risk of electrical shock or re, do
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures war-
ranty. In the unlikely event your unit may require service please contact
your nearest American DJ dealer.
Do not discard the shipping cartoon in the trash. Please recycle when
ever possible.
Specications and improvements in the design of this unit and this
manual are subject to change without any prior written notice.
SAFETY ISSUES:
NEVER POINT OR AIM A F-700 TOWARDS PEOPLE OR THEIR
CLOTHING. THIS UNIT EMITS HOT VAPOR AND SHOULD BE
USED WITH THE SAME CARE THAT YOU WOULD OBSERVE
WHEN USING AN ELECTRIC KETTLE OR IRON.
IF THE POWER SUPPLY CORD IS DAMAGED, IT MUST BE
REPLACED BY MANUFACTURER OR ITS SERVICE AGENT
OR SIMILARLY QUALIFIED PERSON IN ORDER TO AVOID A
HAZARD.
F-700™ Introduction
©American DJ Supply® - www.americandj.com - F-700™ Instruction Manual Page 2
W/ ELECTRONIC
THERMOSTAT
ETS
User Instructions
5/03