Filter
Top Products
A
A - 8
WARRANTY AND SERVICE
SUGGESTED MAINTENANCE PARTS AND LUBRICANTS
BULBS, EXTERIOR
Convenience Light (Dump Valve) # 53, wedge base
License Plate, Clearance Lights # 67
Door Light # 1141
Tail light LED
BULBS, INTERIOR
Shower, Exterior Compartment # 1141
Round Ceiling Light 12V-10W
To change the bulb in the round ceiling light, first remove the lens assembly. The lens
assembly is spring loaded and pops out of the fixture at its chrome ring. A small screw-
driver may be used, be careful not to scratch the chrome and be sure the bulb is cool
before attempting replacement. The bulb inserts into the ballast by two wire prongs.
Grasp the bulb with a piece of cloth and pull it gently straight out from its ballast. Insert
the new bulb, and replace the lens. The lens assembly has two grooves that must be
aligned to the light fixture before snapping the lens back into place.
WARNING: Always replace the light bulb on an interior or exterior light
fixture with the correct bulb for that light. Failure to heed this warning could
cause fire, property damage, personal injury, or death.
FUSES
Radio ATC 15 Amp
Battery Cable Fuses SLC 50 Amp
(Canadian approved trailers only)
Power Center 20 & 30 amp Automotive fuses
Battery Disconnect Relay ATC 5 amp
12-VOLT BREAKERS
50 Amp Type 2
Location: just above the floor on 30 Amp Type 2
roadside interior front end. 20 Amp Type 2
MISCELLANEOUS
Water Hose Gaskets Wheel Bearing Grease
Extra Hair Pin Clips for Hitch Grease Seals
Dry Graphite WD-40 or
Equivalent Aerosol Lubricant
Oil Can with 30 Weight Non-Detergent Oil Silicone Lubricant
Light Household Type Oil Spray Contact Cleaner
Hitch Ball Lube (May use wheel bearing grease.) Exterior Seam Sealer