AB Soft 800HD Offroad Vehicle User Manual


 
April 1, 2006 24 Lit. No. B64090, Rev. 00
ELECTRICAL INSTALLATION – VEHICLE SIDE
12. Connect the power wire (with 15AMPFUSE) to a
switched power source with a minimum of 15
amps.
NOTE: The red power wire MUST be fused and
switched on and off with ignition.
Secure all loose wires under the dash.
13. Install the light tower. Position the arms into the
receiving pockets located on the undercarriage.
Each pocket has a lock pin that secures both light
tower arms. Pull out and twist each handle to
temporarily unlock the pins. Place the light tower
into the pockets and relock the pins. See your
local BLIZZARD dealer for complete installation
instructions for your vehicle undercarriage.
14. Install the plow headlights. Align one headlight
stud on the light tower tube with the mounting hole
and insert the threaded stud through each. Secure
the headlight with one 1/2" galvanized washer
(neoprene facing up), one 7/16" external tooth
lock washer and hex nut.
NOTE: All snowplows are shipped with two caps
that install on the ends of the light tower.
After adding a liberal amount of dielectric grease,
connect the terminals from the plow lights to the
terminals on the main lighting harness.
15. If using a joystick control, align the mount holes
on the joystick control with the holes located on
the mount pedestal.
NOTE: The radius on the pedestal should face the
dashboard.
Secure the joystick to the pedestal with the
8-32 x 3/4" machine screws provided. Slide the
hook and look fastener strap through the slots cut
in the pedestal. The D-ring should be located on
the side opposite of the radius. Wrap the strap
around the bench and fasten.
16. Connect the white power connector from the
vehicle wire harness to the connector on the
control station. The power switch should be in the
"OFF" position.
NOTE: The operation of the draw latch can only be
controlled when the switch on the control is in the
"POWER HITCH™" position and the "RAISE/LOWER"
rocker switch on the A-frame is in the neutral (center)
position.
17. After completing the mechanical and electrical
installations, test all snowplow and lighting
functions before attempting to drive or plow.
Joystick Control
Touchpad Control